MyIPCam for IP cameras에 대한 리뷰
MyIPCam for IP cameras 제작자: Denfllow
리뷰 12개
- 5점 만점에 1점BrunoAragao 님, 3년 전
- 5점 만점에 1점Firefox 사용자 12892113 님, 5년 전
- 5점 만점에 1점Firefox 사용자 14190273 님, 5년 전
- 5점 만점에 1점Firefox 사용자 16834856 님, 5년 전Added this extension to my firefox and went to "manage extension" but NOWHERE did it allow ANY configuration to my IP cams. No 'Autoscan' either. As you stated: "To work you must select the camera model (or you can use 'Autoscan'),... This is a free function of the Extension." So. where do I go to configure?
- For some reason Amcrest is in the dropdown for MPEG (but doesn't work) but it's not in the IP dropdown selection list. So this doesn't work at all for my Amcrest setup.
Edit: Responded to developer, explaining that I can't use Amcrest's web interface since it keeps asking me to install their web client, which I have done several times. This was the reason I installed this extension. Awaiting additional help from developer...개발자 답글
6년 전에 게시됨Try to open web Amcrest camera web interface. Then Open 'Video' settings and select "Encode Mode"=MJPEG for "Sub Stream". Here is full instructions:
https://twitter.com/MyIPCamApp/status/1041722224930181120 - 5점 만점에 1점Firefox 사용자 14051203 님, 8년 전Kept popping up payment request when trying to review, would have been happy to pay a little for this if it wasn't so obnoxious! Also could not find any PTZ controls.
개발자 답글
8년 전에 게시됨How to find PTZ controls: open pop-up window from toolbar, click on video from camera. PTZ buttons will appears below video image.